RiMaServis píše:podložka je rozdělena na 15 zon, a nahřívá se ta část na které je výrobek a autolevel se zaměřuje na 9 bodů, toť vše co mi byla dneska schopna říct děvčica na stánku
![Smile :)](./images/smilies/icon_smile.gif)
)
Tak nevím, jak je to doopravdy s tou zonovostí vyhřívání. V ofiko informacích na anglických stránkách Pruši se píše, že má podložka 3 zony vyhřívání. Tady je celý seznam změn nové I3 -tedy v angličtině
- E3D V6 full with no PTFE in heaterblock, faster printing and 300°C limit
- Z axis with integrated leadscrews as motor shaft (no couplings)
- Beefier extruder motor
- Full automatic mesh bed levelling (compensating even for the curvature of the bed)
- Bed is screwed to the Y axis at 6 points, no adjustment wheels
- Sturdier frame, end of PSU cover is attached to the Y axis
- X and Y endstops are screwed to the parts, Z probe on extruder
- Better cooling which does not cool down the heater block
- Improved extruder body which allows to remove and work on the nozzle without complete disassembling the whole thing
- Better belt attachment system
- Better LCD cover, preventing users from touching the SD card slot and discharging static into the LCD
- Better LCD cable mounting with printed clips (too tight Zipties breaking the cables caused 90% of the LCD problems we've seen)
- Possibility to adjust the X-ends distance
- Better electronics cover with hinged door and better cable support
- Cover for the heatbed cables on the bed
- Custom USB ID -> Win10 slicing support
- 3 zone heatbed, where corners heat more to have more even heating and possibility to print at the edge of the area
- NO GLASS!
- NO ABS JUICE!
- NO BINDER CLIPS!
- PEI build surface
- 250x210x200mm edge to edge printing.