Re: Auto leveling pro Rebel II
Napsal: 25.06.2015 01:08
to Hony: Tu kabelovou punčochu jsi kuchnul z vadnýho PC zdroje a nebo máš nějakýho dodavatele, kterej nechce odběr 100 a více metrů?
Díky
Jirka
Díky
Jirka
Diskuse o 3D tiskárnách Rebel, RepRap atp.
http://www.rebelove.org/
SanityCheck.h:204: error: #error "Z_ENDSTOP_SERVO_NR must be smaller than NUM_SERVOS."
#error "Z_ENDSTOP_SERVO_NR must be smaller than NUM_SERVOS."
^
SanityCheck.h:261: error: #error "Z_ENDSTOP_SERVO_NR must be less than NUM_SERVOS."
#error "Z_ENDSTOP_SERVO_NR must be less than NUM_SERVOS."
^
exit status 1
#error "Z_ENDSTOP_SERVO_NR must be smaller than NUM_SERVOS."
#define Z_ENDSTOP_SERVO_NR
a
#define NUM_SERVOS
#define Z_ENDSTOP_SERVO_NR 1
a
#define NUM_SERVOS 1
#define Z_ENDSTOP_SERVO_NR 0