Stránka 2 z 2

Re: OpenScad - nepoužitelný ?

PříspěvekNapsal: 27.01.2018 12:13
od mgiorgio
Ahoj Rebelove

Trosku som tiez pohral OpenScad-om asi poslednom 10 dni len tak ze som uplne zaciatocnik v tom zatial.

https://www.thingiverse.com/thing:2771687

Zatial este vela veci su pre mna zahadou ale na zaciatocny projekty si myslim ze je celkom pouzitelny.

Re: OpenScad - nepoužitelný ?

PříspěvekNapsal: 30.01.2018 07:28
od Otomar
V popisu na Thingiverse máš "The holes I designed little bit smaller you need drill it with 3.3 -3.5mm" Když pominu všechno ostatní, tak pro M3 šrouby, které tam uvádíš, je to příliš velká díra.

Re: OpenScad - nepoužitelný ?

PříspěvekNapsal: 30.01.2018 17:26
od mgiorgio
Ahoj

mam to tak to "The holes I designed little bit smaller you need drill it with 3.3 -3.5mm
by pillars and bottom or top where comming the lamp holder 2.5mm and cut threat M3"

Pri a bottom top dieli kde idu tie pilary by bolo lepsie trosku vacdie vyvrtat preto som tam pisal 3.3 alebo 3.5 aby M3 skrutka malo by prejst kde su pillar-y a bottom part kde ide lamp holder tam jasne ze tam som dal r =1.3 pre zavit
Zatial to studujem ked tak dam cylinder mensi tak mi tam da sesthran to este musim najst ako to prehodit na kruh

Zatial som vygeneroval a vytlacil dve lampy fotky pridu tam este.

Re: OpenScad - nepoužitelný ?

PříspěvekNapsal: 31.01.2018 02:30
od nasranek
viewtopic.php?f=27&t=2221
příkaz cylinder ( h = 100, r = 10, center=true, $fn = a);
když za "a" dáš 3, 4, 5 ,6 ,7, 8 tak cylinder bude 3, 4, 5 ,6 ,7, 8 hran
na kruh je nejlepší a=100.
Můžeš použít pro každý cylinder samostatně
- cylinder ( h = 100, r = 10, center=true, $fn = 100);
- cylinder ( h = 100, r = 10, center=true, $fn = 6);
nebo globálně
$fn = 6;
$fn = 100;
cylinder ( h = 100, r = 10, center=true);

Re: OpenScad - nepoužitelný ?

PříspěvekNapsal: 05.02.2018 17:29
od mgiorgio
Dakujem to som potreboval