BaudrateFilament printed [m]Printer active [s]Max. inactive time [ms,0=off]Stop stepper after inactivity [ms,0=off]X-axis steps per mmY-axis steps per mmZ-axis steps per mmX-axis max. feedrate [mm/s]Y-axis max. feedrate [mm/s]Z-axis max. feedrate [mm/s]X-axis homing feedrate [mm/s]Y-axis homing feedrate [mm/s]Z-axis homing feedrate [mm/s]Max. jerk [mm/s]Max. Z-jerk [mm/s]X home pos [mm]Y home pos [mm]Z home pos [mm]X max length [mm]Y max length [mm]Z max length [mm]X backlash [mm]Y backlash [mm]Z backlash [mm]X-axis acceleration [mm/s^2]Y-axis acceleration [mm/s^2]Z-axis acceleration [mm/s^2]X-axis travel acceleration [mm/s^2]Y-axis travel acceleration [mm/s^2]Z-axis travel acceleration [mm/s^2]Autolevel active (1/0)Bed Heat Manager [0-3]Bed PID drive maxBed PID drive minBed PID P-gainBed PID I-gainBed PID D-gainBed PID max value [0-255]Extr.1 steps per mmExtr.1 max. feedrate [mm/s]Extr.1 start feedrate [mm/s]Extr.1 acceleration [mm/s^2]Extr.1 heat manager [0-3]Extr.1 PID drive maxExtr.1 PID drive minExtr.1 PID P-gain/dead-timeExtr.1 PID I-gainExtr.1 PID D-gainExtr.1 PID max value [0-255]Extr.1 X-offset [steps]Extr.1 Y-offset [steps]Extr.1 temp. stabilize time [s]Extr.1 temp. for retraction when heating [C]Extr.1 distance to retract when heating [mm]Extr.1 extruder cooler speed [0-255]Extr.2 steps per mmExtr.2 max. feedrate [mm/s]Extr.2 start feedrate [mm/s]Extr.2 acceleration [mm/s^2]Extr.2 heat manager [0-3]Extr.2 PID drive maxExtr.2 PID drive minExtr.2 PID P-gain/dead-timeExtr.2 PID I-gainExtr.2 PID D-gainExtr.2 PID max value [0-255]Extr.2 X-offset [steps]Extr.2 Y-offset [steps]Extr.2 temp. stabilize time [s]Extr.2 temp. for retraction when heating [C]Extr.2 distance to retract when heating [mm]Extr.2 extruder cooler speed [0-255]